A workstation's network board is currently configured as follows: Network Speed = Auto Duplexing = Auto The workstation is experiencing poor network performance, and you suspect that the network board is incorrectly detecting the network speed and duplex settings. Upon investigation, you find that it's running at 10 Mbps half-duplex. You know that your network switch is capable of much faster throughput. To fix this issue, you decide to manually configure these settings on the workstation. Before you do so, you need to verify the switch port configuration for the connected workstation. Given that it's a Cisco switch, which commands can you use on the switch to show a list of all switch ports and their current settings? (Select two.)