Week 5 Report - Extraction of Caffeine (2pts) Extraction of Caffeine How will you collect data for this experiment? virtually Report Sheet Extraction of Caffeine From the procedure Obtain 2 uncoated alertness aid tablets and measure and record their combined mass. Mass of 2 whole uncoated alertness aid tablets (g) Note: The balance was tared with the weighing paper 0.706 g 0.706 From the procedure Crush the tablets into a powder using a clean mortar and pestle. Obtain a mass of the crushed tablets. Record this mass in the report sheet. Mass of 2 crushed alertness aid tablets (g) Note: The balance was tared with the weighing paper 0.703 g 0.703 From the procedure Place the crushed tablets in a beaker containing about 60 mL of DI water and about 8 g of sodium carbonate. Add one boiling stone to the beaker and heat the mixture to boiling on a hot plate. Maintain the mixture at boiling for 2 minutes or so, and then stop the heating and allow the contents of the beaker to settle. There will be tablet binder material remaining undissolved. Assemble an iron ring and glass funnel on the ring stand above a 125 mL separatory funnel so that the stem of the glass funnel is positioned in the middle of the separatory funnel. Place a medium-sized wad of glass wool into the bottom of the glass funnel to create a filter. Alternatively, you could use a pieces of filter paper folded into a cone. Quickly but carefully filter the alertness aid pill mixture through the the glass funnel directly into the separatory funnel. Rinse the residue remaining in the glass wool (or filter paper) in the funnel with a small amount of water. Allow the aqueous filtrate in the separatory funnel to cool to room temperature. Do not add volatile dichloromethane to a warm solution in the separatory funnel! Add 7 mL of dichloromethane to the separatory funnel. As you add the dichloromethane, note whether the dichloromethane is the top or bottom layer. Place the stopper in the neck of the separatory funnel. Shake gently, invert the funnel while holding the stopper securely in the neck, and vent the separatory funnel through the stopcock. The caffeine will be extracted from the aqueous phase into the organic phase. Drain the organic layer into a small Erlenmeyer flask. Add two more portions of 7 mL of dichloromethane, repeating the extraction and draining the organic layer into the same small Erlenmeyer flask after each addition. Once the 3 extracts have been collected, add sufficient drying agent (sodium sulfate or magnesium sulfate). Let the extracts and drying agent sit undisturbed for several minutes after adding sufficient drying agent. Carefully decant the dried dichloromethane solution into a clean and pre-weighed small beaker (50 mL) and then gently evaporate the solvent away IN THE HOOD on the low setting of a hot plate. After evaporation, measure the mass of the crude product in the beaker. Record this value in the report sheet. Mass